Knoll Systems Stereo Receiver IR320 User Manual

IR320 Infrared Receiver Specifications:  
IR320  
Installation Instructions v1.0  
Micro Infrared Receiver  
Specifications  
Infrared carrier frequency: 25-65 kHz  
Indoor reception range:  
Nominal reception angle:  
Maximum wire length:  
100 feet (30 meters) max.  
50 degrees off axis  
1000’ (300m) or even more with  
larger gauge wire  
Warning: To be installed and/or used in accordance with  
appropriate electrical codes and regulations.  
Introduction: Thank you for your purchase of a Knoll IR320  
infrared receiver. This receiver features the ability to pick up a  
remote control infrared signal and relay it on wires to the inside  
of a cupboard or to another location up to 1000’ (or more).  
Wire requirements:  
3 conductors, minimum 24-gauge  
to 200’; 22-gauge up to 500’;  
20-gauge to 1000’  
12VDC, 40mA  
15/19” x 3/8” x 1/2" h  
Power requirements:  
Dimensions:  
(24 mm x 10 mm x 13mm h)  
Actual size  
Requires 12VDC power supply, emitter(s) and a  
connection block.  
Features:  
Very small design.  
More forgiving than previous  
designs and can work short  
distances in direct sunlight.  
Will relay almost all remote  
control types.  
Requires very little power. Suggest using Knoll PS1205  
for up to ten IR320’s.  
Warranty  
Knoll Systems warrants its products (with certain exceptions) sold in the USA  
and Canada by authorized Knoll dealers to be free of defects in materials and  
workmanship. This warranty extends for three full years from the date of  
purchase by the original consumer. Any products returned to Knoll Systems and  
found to be defective by Knoll Systems within the warranty period will be  
repaired or replaced at Knoll Systems option, at no charge. Knoll Systems will  
not be responsible for the actual cost of installation or removal of the product,  
nor for any incidental or consequential damages. Some states do not allow the  
exclusion or limitation of incidental or consequential damages, so the above  
limitation may not apply to you. This warranty gives you specific legal rights.  
You may have additional legal rights that vary from state-to-state.  
Up to ten Knoll infrared receivers can be connected in a  
single system.  
Available in black, white and silver colors.  
Connects with a three wire connector or 3.5mm plug.  
Installation Tips  
1. Follow all local electrical & building code requirements.  
145 Tyee Drive Point Roberts, WA 98281  
14-7163 Vantage Way, Delta BC V4G 1N1  
Telephone: (604) 940-1689, Fax (855) 734-3363  
2. The IR320 is usually mounted to the wall or cabinet using the  
included double sided tape. For easy installation and to ensure  
reliability, it is suggested to use a Knoll PS1205 power supply,  
Knoll single or dual emitters and a Knoll connection block or  
hub.  
Made in Canada Knoll Systems All Rights Reserved  
 

Ingersoll Rand Marine Sanitation System 65142X XX User Manual
Integra DVD Player DPC 74 User Manual
Iqua Headphones BHS 302 User Manual
JVC Car Amplifier KW NT50HDT User Manual
JVC Cassette Player KS F100 User Manual
JVC Flat Panel Television AV 27115 User Manual
JVC Headphones HANC250 User Manual
Kalorik Blender USK BL 16909 User Manual
Klipsch Speaker ULTRA2 User Manual
Konftel Conference Phone 55W User Manual